Black & Decker KS500 Original Instructions Manual page 5

that cannot be controlled with the switch is
dangerous and must be repaired.
c. Disconnect the plug from the power source
and/or the battery pack from the power tool
before making any adjustments, changing
accessories, or storing power tools. Such
preventive safety measures reduce the risk of
starting the power tool accidentally.
d. Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e. Maintain power tools. Check for
misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tools operation.
If damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to
control.
g. Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from those intended could
result in a hazardous situation.
5. Service
a. Have your power tool serviced by
a qualifi ed repair person using only
identical replacement parts. This will make
sure that the safety of the power tool is
maintained.
Additional power tool safety warnings
Warning! Additional safety warnings for
jigsaws.
♦ Hold power tool by insulated gripping
surfaces, when performing an operation
where the cutting accessory may contact
hidden wiring or its own cord. Cutting
accessory contacting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
♦ Use clamps or another practical way to
secure and support the workpiece to
a stable platform. Holding the work by hand or
against your body leaves it unstable and may
lead to loss of control.
♦ Keep hands away from cutting area. Never
reach underneath the work piece for any
reason. Do not insert fi ngers or thumb into the
vicinity of the reciprocating blade and blade
clamp. Do not stabilize the saw by gripping the
shoe.
♦ Keep blades sharp. Dull or damaged blades
may cause the saw to swerve or stall under
pressure. Always use the appropriate type of
saw blade for the workpiece material and type
of cut.
♦ When cutting pipe or conduit, make sure
that they are free from water, electrical
wiring, etc.
♦ Do not touch the workpiece or the blade
immediately after operating the tool. They
can become very hot.
♦ Be aware of hidden hazards, before cutting
into walls, fl oors or ceilings, check for the
location of wiring and pipes.
♦ The blade will continue to move after
releasing the switch. Always switch the
tool off and wait for the saw blade to come to
a complete standstill before putting the tool
down.
Warning! Contact with, or inhalation of dusts
arising from cutting applications may endanger the
health of the operator and possible bystanders.
Wear a dust mask specifi cally designed for
protection against dust and fumes and ensure that
persons within or entering the work area are also
protected.
♦ The intended use is described in this instruction
manual. The use of any accessory or
attachment or performance of any operation
with this tool other than those recommended
in this instruction manual may present a risk of
personal injury and/or damage to property.
Safety of others
♦ This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning the use of the appliance by
a person responsible for the their safety.
♦ Children should be supervised to ensure that
they do not play with the appliance.
ENGLISH
5