Setting Up The Network; Opening And Closing Emp Monitor - Epson PowerLite 7900p Product Information

Setting Up the Network

Connect each projector you want to monitor to your network
and configure it with an appropriate IP address.
1. Connect the projector to your network using a
commercially available 100baseTX or 10baseT network
cable. Plug the cable into the projector's Ethernet port.
Ethernet port
To network port
2. Turn on the projector.
3. Press the button on the remote control and select
Menu
from the
Network Advanced2
Video Video
Brightness Control Brightness Control
Audio Audio Projector ID Projector ID
Effect Effect Network Network
Setting Setting
COM Port COM Port
User's Logo User's Logo Auto setup Auto setup
Advanced1 Advanced1 BNC Sync Termination BNC Sync Termination
Advanced2 Advanced2 Reset Reset
About About
Reset All Reset All
[ [ ]: Select ]: Select [ [ ]: Enter ]: Enter
4. If your network assigns addresses automatically, turn on
.
DHCP
5. If your network does not assign addresses automatically,
turn off and enter the projector's
DHCP
, and
Subnet Mask Gateway Address
To enter numbers using the remote control, press the
button until it lights, then use the numeric
Num
keypad.
Num button
menu.
:
High High Low Low
: 1 : 1
Set Set
Select
Set Set
: RS-232C RS-232C USB USB
Network
:
ON ON OFF OFF
:
ON ON OFF OFF
Execute Execute
[Menu]: Exit [Menu]: Exit
,
IP Address
, as needed.
Zero
Epson PowerLite 7900p Projector
To change the network addresses from the projector's
control panel, press the right and left arrow buttons to
select the part of the address you want to enter, then
use the up and down arrow buttons to increase or
decrease the numeric value.
Select the part of the
address to change
Note: If you're a network administrator, you can use the
option to enter a trap IP address. This lets you receive
SNMP
trap alerts for the projectors you're monitoring. If you have
HP OpenView, a plug-in is available to allow you to manage
your projectors in HP OpenView. Check with your dealer or
Epson.
When you finish changing an address in the network menu,
press the button (on the remote control) or the
Enter
button (on the projector). This stores the
Auto/Enter
value.
6. When you're done making all necessary changes, press
to exit the menu system.

Opening and Closing EMP Monitor

To start EMP Monitor, click
Programs > Epson Projector > EMP Monitor
If you've added the program to the Startup programs folder, it
may already be open. If so, click the icon in the system tray on
the lower-right corner of your screen to display the EMP
Monitor window:
To close EMP Monitor, right-click the program icon shown
above, then select
Exit
9/04 Epson PowerLite 7900p Projector
Start > Programs
.
Click here to start EMP Monitor
.
Increase or
decrease
the value
ESC
or
All
15
-