Using The Direct Power On Function; Shutting Down The Projector - Epson PowerLite 450W User Manual

Using the Direct Power On Function

The Direct Power On function enables faster setup. The projector
starts up automatically when you plug it in or turn it on with a wall
switch. You don't have to press the Ppower button.
Follow these steps to enable Direct Power On:
1. Press the button on the remote control or projector, then
Menu
select the
Extended
2. Choose
Operation
3. Choose
Direct Power On
4. Highlight and press
On
5. Press to exit. The setting will take effect the next time you
Menu
plug the projector into a power outlet or turn it on with a wall
switch.

Shutting Down the Projector

This projector incorporates Instant Off technology. To turn it off, you
can press its Ppower button as described below, unplug it, or turn off
a power switch that supplies power to the projector. You don't have to
wait for the projector to cool down first.
1. To turn off the projector, press the Ppower button on the remote
control or projector.
You see a confirmation message.
(If you don't want to turn it off,
press any other button.)
2. Press the Ppower button again. The projection lamp turns off
and the projector beeps twice. You can then unplug the power
cord.
menu and press
Enter
and press .
Enter
and press
Enter
.
Enter
.
.
Displaying and Adjusting the Image
note
If a power outage occurs
when Direct Power On is
enabled and the projector is
plugged in, the projector will
restart when the power is
restored.
note
Lamp life will vary
depending upon mode
selected, environmental
conditions, and usage.
Turn off this product when
not in use to prolong the life
of the projector.
You can set the projector to
automatically turn off the
lamp and enter "sleep mode"
when it has not received any
signals for 1 to 30 minutes
(see page 68). This conserves
electricity, cools the
projector, and extends the
life of the lamp. If you want
to start projecting again,
press the P power button.
27