Adjusting The Audio From External Devices; Using An External Audio System Or Digital Audio Recorder - Epson MovieMate 25 User Manual

Note: After you disconnect your external equipment, make sure you close MovieMate's port
compartment cover.

Adjusting the Audio from External Devices

You can use all of MovieMate's audio controls, as described on pages 31 and 32.
You can also adjust the volume input level by pressing and holding the button for
approximately 2 seconds. appears on MovieMate's display window. Press and hold
LEVEL 1
the button again to select and increase the volume.
LEVEL 2

Using an External Audio System or Digital Audio Recorder

You can connect MovieMate to an AV amplifier, surround sound system, or digital audio
recorder. To output sound from MovieMate, the external equipment needs to have an optical
audio input port.
You will also need an optical digital cable, which may be provided with your external
equipment, or may be purchased from an electronics store.
1. Remove the protective cap from the Optical Audio-Out port as shown below.
2. Make sure the equipment is turned off, then connect the cable as shown:
Digital audio recorder
AV amplifier
Optical digital cable
You may need to adjust the volume or change the or
Digital Audio Output Downmix
settings in the Audio Setup menu. See page 32 for more information. Make sure you use the
setting for surround sound systems.
Stream/PCM
Note: After you disconnect your external audio equipment, make sure you replace the cap on the
Optical Audio Out port and close MovieMate's port compartment cover.
37
Doing More with MovieMate