Filling The Salt Reservoir; Replenishing Salt - Miele PFD 104 SCVi Operating Instructions Manual

Commissioning

Filling the salt reservoir

Before filling the salt reservoir for the
first time, you must fill it with approx.
2 litres of water to enable the salt to
dissolve.
Once the dishwasher has been used,
there is always sufficient water in the
salt reservoir.
 Remove the lower basket from the
wash cabinet and unscrew the salt
reservoir cap.
 Fill the salt reservoir with approx.
2 litres of water (first use only).
 Place the funnel provided over the
salt reservoir and carefully fill with
dishwasher salt until the reservoir is
full. The salt reservoir holds up to
2 kg of salt, depending on the type of
salt used.
 Clean off salt residues from around
the salt reservoir opening. Next,
screw the salt reservoir cap on again
firmly.
28

Replenishing salt

 When 
Refill salt
display, wait until the end of the
programme and then refill the salt
reservoir.
 Confirm with OK.
The salt refill indicator will go out.

Risk of corrosion due to saline
solution.
Saline solution that runs out can
cause corrosion in the wash cabinet
and to the dishwasher load.
Each time you have opened the salt
reservoir cap, immediately run the
 Cold pre-wash programme
without any dishes. This will dissolve
and remove any traces of salt from
the wash cabinet.
After the salt reservoir has been filled,
the salt refill indicator may still appear in
the display if the salt concentration has
not yet reached the correct level. In this
case, confirm the message again with
OK.
appears in the