Problems And Solutions - Epson Stylus NX100 Series Quick Manual

Light status
B ink light flashing
B ink light on
All lights are on
All lights are flashing

Problems and Solutions

Check the solutions below if you're having trouble using your NX100 Series.
Printing and Copying Problems
■
Make sure your original is positioned in the front right corner of the glass. If
the edges are cropped, move your original away from the edges slightly.
■
Make sure your paper is loaded short edge first and is positioned against the
right side with the edge guide against its left side. Don't load paper above the
arrow mark inside the edge guide.
■
Make sure the paper size settings are correct for the paper you loaded.
Problem and Solution
One or more cartridges have low ink. You can continue
printing until a cartridge needs replacement. Check the
cartridge status to determine which cartridges are
affected (see page 22).
One or more ink cartridges are expended, incorrectly
installed, or cannot be used with the printer. If an ink
cartridge is likely to be expended, you must replace the
cartridge to be able to print. If you just replaced a
cartridge and the light is still on, the cartridge is not
installed correctly. Press the y Stop button to move
the cartridges to the replacement position. Press down
on all the installed cartridges, then press the y Stop
button to continue.
Parts inside the NX100 Series are at the end of their
service life. Contact Epson for help (see page 31).
There is a problem with the NX100 Series. Turn it off,
wait a few moments, and turn it back on again. If the
error is not resolved, contact Epson for help (see
page 31).
Problems and Solutions
29