Functional Description; Important Charging Notes - Black & Decker BDCS20 Instruction Manual

FUNCTIONAL
DESCRIPTION
1) SWITCH
2) FORWARD / REVERSE / LOCK
OFF SLIDER
3) HEX SPINDLE
4) CHARGING PORT
5) CHARGING PLUG
6) CHARGER
(1) The charging port (4) is keyed to lock out
other chargers. Align the tab in the charger
plug (5) with the key in the charging socket.
(2) Plug the charger output plug (5) into the
charging port (4) of the tool as shown in
figure B.
(3) Plug the charger (6) into any standard 120
Volt 60 Hz electrical outlet.
(4) Let the tool charge initially for at least 23
hours. After the initial charge, your tool should
be fully charged in 23 hours from a fully
discharged condition. Recharge discharged
batteries as soon as possible after use
or battery life may be greatly diminished.
For longest battery life, do not discharge
batteries fully. It is recommended that the
batteries be recharged after each use.
WARNING: Do not use tool while it is
connected to the charger.
WARNING: Fire Hazard. When disconnecting the charger from the tool, be sure to
unplug the charger from the outlet first, then disconnect the charger cord from the tool.

Important Charging Notes

1. Your tool was sent from the factory in an uncharged condition. Before attempting to
use it, it must be charged for at least 9 hours.
2. CAUTION: To reduce the risk of damage to the batteries, NEVER charge them in
an air temperature below 40°F (4,5°C) or above 105°F (40,5°C). Also, NEVER
charge them if the battery temperature is below 40°F (4,5°C) or above 105°F
(40,5°C). Longest life and best performance occurs when batteries are charged with
an air temperature of approximately 75°F (24°C).
3. While charging, the charger may hum and become warm to touch. This is a normal
condition and does not indicate a problem.
A
3
5
B
6
2
1
6
4
4
5