Troubleshooting - Sharp KD-GHB8S7GW2-DE User Manual

8. TROUBLESHOOTING

Your dryer is fitted with systems that continuously perform checks during the drying
process to take the necessary measures and warn you in case of any malfunction.
WARNING: If the problem persists even if you have applied the steps in this section,
please contact the your dealer or an Authorised Service Provider. Never try to repair a
nonfunctional product.
PROBLEM
The drying process takes a long
time.
Laundry comes out damp at the end
of the drying process.
The dryer cannot be opened or the
programme cannot be started. The
dryer does not get activated when
adjusted.
The programme has been
interrupted for no reason.
REASON
The surface of the lint filter might be
clogged.
The heat exchanger might be
clogged.
The ventilation grills in front of the
machine might be closed.
There might be a layer of limescale
on the humidity sensor.
The dryer might be overloaded with
laundry.
The laundry might be insufficiently
spun.
The laundry that comes out hot at the end of the drying process
generally feels more humid.
The programme used might not be
suitable for the type of laundry.
The surface of the lint filter might be
clogged.
The heat exchanger might be
clogged.
The dryer might be overloaded with
laundry.
The laundry might be insufficiently
spun.
The dryer might not be plugged in.
The loading door might be open.
You might not have set a
programme or pressed the Start/
Pause key.
Child lock might be active.
The loading door might not be
closed properly.
There might have been a power
failure.
The water tank might be full.
EN - 25
SOLUTION
Wash the filter with lukewarm water.
Wash the heat exchanger
Open the doors/windows to prevent
the room temperature from rising
too much.
Clean the humidity sensor.
Do not overload the dryer.
Select a higher spin speed on your
washing machine.
Check the care labels on the
laundry items, select a suitable
programme for the type of laundry
and additionally, use the time
programmes.
Wash the filter with lukewarm water.
Wash the heat exchanger
Do not overload the dryer.
Select a higher spin speed on your
washing machine.
Make sure that the plug is fitted in
the socket.
Make sure that the loading door is
properly closed.
Make sure that the programme has
been set and the dryer is not in the
Standby (Pause) mode.
Deactivate the child lock.
Make sure that the loading door is
properly closed.
Press the Start/Pause key to start
the programme.
Empty the water tank.