Installation And Adjustment - Haier HWM105-M186 Owner's Manual

Installation and adjustment

For your security and to ensure correct operation of the machine, please install and
adjust the machine according to this manual's instructions.
Installation of the lint filter
Place the bottom side of the lint filter in to the overflow
filter , then push the top side into the overflow filter.
After installation, please double check to make sure
that the lint filter is installed in the correct location;
otherwise it may fall off during operation.
On model HWM105-M186
Drain hose usage
Drain hose drainage should be smooth and unobstructed.
1.The height of the drain hose shall be less than 10cm,
or the drainage will not be smooth enough and cause
incomplete drainage.
2.Do not tramp or press the drain hose.
3.If the drain hose is too long, cut it at mid point.
To make smooth drainage, cut the front end of
the hose slantingly.
4.If extra drain hose is needed, please make
separate purchase. The inner diameter of the
extra hose shall not less than 30mm,and the
length shall not exceed 1.5m.
5.If the extra hose is too long, cut it either at point A or B.
overflow filter
lint filter
On models HWM130-M186,HWM150-M186
5
overflow filter
lint filter