Husqvarna 125B Operator's Manual page 9

5. Install the screw (D) and tighten with a
screwdriver to attach the tube.
A
D
To attach the vacuum tubes together
1. Align the arrow on the lower vacuum tube (A)
with the arrow on the upper vacuum tube (B).
2. Push the lower vacuum tube into the upper
vacuum tube.
3. Use a screwdriver to install the self-tapping
screw (C) that holds the tubes together.
A
C
To install the vacuum tubes
1. Insert the tip of a screwdriver into the latch area
of the vacuum inlet.
2. Turn the screwdriver to release the latch.
214 - 008 - 23.09.2021
C
B
B
3. Hold the vacuum inlet cover open until the upper
vacuum tube is in place.
4. Align the ribs on the inside of the vacuum inlet
with the slots on the upper vacuum tube. Make
sure the lock symbol on the tube aligns with the
unlock symbol on the vacuum inlet.
5. Push the upper vacuum tube fully onto the
vacuum inlet.
6. Turn the upper vacuum tube clockwise until the
lock symbol on the tube aligns with the lock
symbol on the vacuum inlet. The tube makes a
click when it is correctly attached.
9