Freezer Door Reversal - Black & Decker BUFK12W Instruction Manual

SET UP & USE

FREEZER DOOR REVERSAL

Before reversing the door, ensure the
appliance is unplugged and empty.
Provide additional support for the doors
while hinges are being removed. Do not
depend on the door magnets to hold the
door in place. It is recommended that
two people perform this task. DO NOT
lay the appliance completely flat as this
may damage the coolant system.
1. Remove any loose items from inside
the freezer (e.g. drip pan, ice tray,
etc.)
2. Using a flat head screwdriver remove
the top hinge cover (A).
3. Loosen and remove the two screws
(B) using a Phillips head screwdriver
while holding the upper hinge in
place.
4. Remove the upper hinge (C) and
carefully lift off the door. Place the
door safely to the side.
5. Using a flat head screwdriver remove
the screw hold plug (D) from the
opposite side and insert the plug into
the screw hole openings of the just
removed screws.
6. Carefully lay the freezer on its back
on a flat secure area.
7. Using a Phillips head screwdriver,
loosen and remove the two screws
(E) holding the bottom hinge (F) in
place. Place the hinge and screws to
the side momentarily.
8. Place the bottom hinge (F) on the
opposite side and insert and tighten
the two screws (E) securely.
Page 8
9. Place the freezer in its upright
position. Remove the door plug (H)
on the top of the door and insert it
firmly in the hole on the opposite
side. Align the hole in the door
bottom with the pin of the bottom
door hinge (F) and gently push down
until firmly in place.
10. Holding the door in the open position
place the pin of the upper door
hinge (C) into the hole located on
the top of the door. Align the screw
holes of the upper hinge (C) with the
screw holes on the top corner of the
cabinet and insert and tighten loosely
the two screws (B).
11. Check that the door is aligned and
level and then securely tighten the
upper hinge screws.
12. Replace the upper hinge cover (A)
by gently snapping it into place.
D A B
C
H
F
E
G