Troubleshooting - Craftsman CMXGVAM1144036 Instruction Manual

This section addresses minor service issues. To locate the nearest authorized service center or to schedule service, call the following toll free number:
1-888-331-4569.
Problem
Wheels/Tines will not turn
Tines turn, but wheels don't
Wheels turn, but tines Don't
Poor tilling performance

TROUBLESHOOTING

Disconnect the spark plug wire and ground it against the engine to prevent
unintended starting. Before performing any type of maintenance/service,
disengage all controls and stop the engine. Wait until all moving parts
have come to a complete stop. Always wear safety glasses during operation
or while performing any adjustments or repairs.
Cause
1. Improper use of controls.
2. Worn, broken, or mis-adjusted drive belt(s).
3. Internal transmission wear or damage.
4. Bolt loose in transmission pulley.
1. Wheel Drive Pins not in WHEEL DRIVE.
2. Bolt loose in transmission pulley.
3. Internal transmission wear or damage.
1. Tine holder mounting hardware missing.
2. Bolt loose in transmission pulley.
3. Internal transmission wear or damage.
1. Worn tines.
2. Improper Depth Regulator setting.
3. Forward Drive Belt slipping.
WARNING
1. Review Operation section.
2. Replace or adjust belts.
3. Contact local authorized dealer.
4. Tighten bolt.
1. Inserts Drive Pins properly.
2. Tighten bolt.
3. Contact local authorized dealer.
1. Replace hardware.
2. Tighten bolt.
3. Contact local authorized dealer.
1. Replace Tines.
2. See "Tilling Tips & Techniques."
3. See Maintenance & Adjustments Section.
19
Remedy