Inserting The Card - Epson Stylus CX5000 Series Quick Manual

Inserting the Card

1. Make sure the Epson Stylus CX5000 Series all-in-one is turned on.
Note:
When you print directly from a memory card, it is best if the CX5000 Series is not
connected to your computer (or your computer should be turned off). If you see a
message on your computer screen when you insert a card in the CX5000 Series,
just cancel the operation and close the screen.
2. Open the memory card door.
3. Make sure the memory card access light is off and that no cards are in any of
the slots. Then insert your card into the correct slot (see page 13 for details).
The memory card access light flashes and then stays on.
4. Close the memory card door. Now you can:
■
Print an index sheet so you can select which photos to print (see page 15)
■
Print all the photos on the card (see page 17)
■
Print photos pre-selected on your camera using DPOF (see page 17)
When you want to remove the card, make sure the memory card access light is not
flashing, then pull the card straight out of its slot.
Caution:
Do not remove the card or turn off the CX5000 Series while the memory card access
light is flashing; you may lose data on the card.
14
Printing From a Memory Card
Insert just one card at a time (it won't go in all the way)
Left slot Right slot
Memory card
access light