Table of Contents
Advertisement
Section 3 - mydlink
1
Device Photo
2
Device Name
3
Device Location
4
Wi-Fi
5
Designated Contact
Camera
6
Microphone
7
Motion Setting
8
Night Vision
9
Anti-Flicker
10
Camera LED
11
Privacy Mode
12
Invert Image
13
Storage
14
Firmware Update
Current Firmware
15
Version
16
Device ID
17
Remove Device
D-Link DCS-8000LHV2 User Manual
Tap to add a customized photo of this device.
Tap to change the device's name.
Tap to change or add a new location for this device.
Tap to change the wireless network this device will use to connect
to the Internet.
Note: The network must be the same as all your other mydlink devices that you
wish to use the same account for.
Tap to add, remove, or edit designated contacts that appear in the
rich notification.
Tap to enable or disable the device's microphone.
Tap to further configure sensitivity and the active area of motion
detection.
Tap to change night vision detection to On, Off or Auto.
Reduces flicker in the video. Tap 50Hz or 60Hz depending on the
frequency of your lights.
Disabling this will turn off the LED until you turn it back on.
Tap to enable Privacy Mode. Privacy mode will disable the camera
feed.
Enable this to invert the camera view.
Tap to view the storage location and your current subscription plan.
Shows time of auto firmware upgrade. Tap to enter the firmware
upgrade settings. You can choose the most suitable time for
automatic updates.
This displays your devices' firmware version
Identifies the device for support issues.
Tap this button to disconnect this device from your mydlink account.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
15
Advertisement
Table of Contents
