Encore ENPS-MF1 Specifications

1 port usb multifunctional print server

Hide thumbs Also See for ENPS-MF1:

1 Port USB Multifunctional Print Server

Product Descriptions:

A. Interface:

USB: One USB 2.0 High speed compliant port, supporting 1.5 Mbps (low

speed), 12 Mbps (full speed) and 480 Mbps (high speed) data transmission rate.

This port automatically detects the make and model of the printer attached to

it.

LAN: Compliant with IEEE 802.3 / 802.2u standard, 10/100 Mbps auto

sensing, RJ 45 (UTP) connector.

* This product does not support use of USB hubs for daisy-chained connection, USB-to-Parallel

connectors, or USB cable extenders.

ENPS-MF1

Table of Contents

Do you have a question about the ENPS-MF1 and is the answer not in the manual?

Page 1: Product Descriptions
This port automatically detects the make and model of the printer attached to LAN: Compliant with IEEE 802.3 / 802.2u standard, 10/100 Mbps auto sensing, RJ 45 (UTP) connector. * This product does not support use of USB hubs for daisy-chained connection, USB-to-Parallel connectors, or USB cable extenders. ENPS-MF1...
Page 2 B. Key Software Specifications: Setup CD Network Operating System Support Network Protocol Support* DHCP (client) Support Management Firmware Upgradeable MFP Support C. Hardware Specifications: Embedded high-performance RISC-cored SoC processor Flash System Memory 2 MB SDRAM USB Port USB 2.0 standard compliant host controller LAN Port 10/100 Mbps, auto-sensing Reset Button...