Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Graymills LIFTKLEEN TR Series
Summary of Contents for Graymills LIFTKLEEN TR Series
- Page 1 795-92950_0414 Operation and Maintenance Instructions TR-SERIES LIFTKLEEN ® PARTS WASHER— SOLVENT/UNHEATED For units manufactured after January 2011 Read all of the SAFETY INSTRUCTIONS in this manual BEFORE installing or using this equipment. Keep this manual handy for reference/training.
-
Page 2: General Warnings
• If you have any questions regarding the correct fluids to use in this unit, call Graymills at (773) 248-6825 and ask for Never work with equipment you feel may be unsafe. Contact Customer Service. Graymills recommends our Agitene line ®... -
Page 3: General Safety Instructions
See Safety Procedure for CONNECTING AIR SUPPLY (page 4). as gloves, apron, safety glasses or goggles. If you have any questions regarding the recommended fluids to use in this unit, call Graymills at (773) 248-6825 and ask for GETTING STARTED Customer Service. -
Page 4: Connecting Air Supply
For replacement, contact Graymills for correct part. 4. Momentarily raise and release the toggle switch (1C). The Do NOT contaminate the solvent with gasoline or other platform should begin oscillating up and down with an flammable liquids with a flash point below 104°F as a severe... -
Page 5: Maintenance
3. Each time you remove the lift platform for cleaning, inspect to the load/unload position. the lift arm. Contact Graymills if wear is evident. Load the parts to be cleaned in a parts basket and place the basket on the lift platform. Larger parts may be loaded directly on the lift platform. - Page 6 Powering Down a Timer-Equipped Unit When the unit is not in use, it is recommended that the lift platform be sent to the lower position and lid closed (this will Do NOT exceed weight limit of platform. reduce heater power consumption on heated units and reduce Use appropriate lifting techniques for heavy parts.
-
Page 7: Troubleshooting Guide
Air pressure may be too low to lift load Increase air pressure to 100 psig lifting and lid If your problem is not listed above or problems persist, please contact Graymills for further assistance.1-888-472-9645 795-92950_0414 Unheated TR-Series Operation and Maintenance Instructions 7... -
Page 8: Pump And Motor
Safety Link Assembly (Figure 5) 738-92351 3-way Bleed Valve OAP-25 To extend life of heated fluids, order Graymills PUMP AND MOTOR Oil Absorbent Pads (Part No. OAP-25) which are ideal for surface oil removal. Consult factory. Have pump model number on hand. -
Page 9: Warranty
Buyer’s remedies thereunder (except to title) are within ninety days of any defect or failure and satisfactory solely and exclusively stated herein. In no case will Graymills proof thereof. be liable for consequential damages, loss of production or any Before Graymills can repair or replace a defective part other loss incurred due to interruption of service.
Need help?
Do you have a question about the LIFTKLEEN TR Series and is the answer not in the manual?
Questions and answers