Selecting Installation Location
The room temperature sensor is inside the controller, so the installation
location is critical to proper system operation. Install the controller in a
location away from direct sunlight, high humidity, and direct flow of hot or
cold air. Install the controller on a flat, clean wall surface approximately 5 ft
above the floor in an area with good circulation and average temperature.
Do not install the controller where it is exposed to:
• Drafts or dead spots behind doors and in corners
• Hot or cold air from ducts
• Radiant heat from sun or appliances
• Concealed pipes or chimneys
• Uncontrolled areas such as on an outside wall
Refer to Figure 1 for a typical installation location.
no
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
CONTROLLER INSTALLATION
Figure 1: Typical Controller Location
yes
09-26-2017
2:43 PM
Occ Auto Heat
Auto
Indoor °F
74°
78
Humidity
68
66 %
Locked by central controller
09-26-2017
2:43 PM
Occ Auto Heat
Auto
no
Indoor °F
74°
78
Humidity
68
66 %
Locked by central controller
5ft
no
9