EWC Controls EWT-725 Installation Manual page 4

Programming
Set Time
(If using programming)
1.
With system switch set to OFF, press the MENU button
2. Press SET TIME
3. Day of the week will be flashing. Use the
to select the current day of the week.
4. Press NEXT STEP
5. The current hour is flashing. Use the
select the current hour. When using 12-hour time, make sure
the correct a.m. or p.m. choice is selected.
6. Press NEXT STEP
7. Minutes are now flashing. Use the
select current minutes.
8. Press DONE when completed.
Programming
Set Program Schedule 5+1+1 or 7 Day
To customize your program schedule, follow these steps:
1. Select HEAT or COOL with the system switch. Note: You
have to program heat and cool each seperately.
2. Press the MENU button
3. Press SET SCHED. Note: Monday-Friday or
is displayed and the WAKE icon is shown. You are now
programming the wake time period for that day.
4. Time is flashing. Use the
time selection for that day's WAKE time period.
5. Press NEXT STEP
6. The setpoint temperature is flashing. Use the
key to make your setpoint selection for that day's WAKE
time period.
7. Press NEXT STEP
8. Repeat steps 4 thru 7 for that day's LEAVE time period,
RETURN time period, and SLEEP time period.
Saturday:
Repeat steps 4 through 7 for the Saturday WAKE time period, LEAVE time
period, RETURN time period, and for the Saturday SLEEP time period.
Sunday:
Repeat steps 4 through 7 for the Sunday WAKE time period, LEAVE time
period, RETURN time period, and for the Sunday SLEEP time period.
or
or
or key to
(If menu does not appear first press RUN SCHED)
(Monday if in 7 Day)
or key to make your
Programming
Programming
All of our programmable thermostats are shipped with an
energy saving pre-program. You can customize this default
program by following the steps on page 15.
key
There are four time periods for each program (WAKE, LEAVE,
RETURN, SLEEP).
key to
Programming
Set Program Schedule 5+1+1 or 7 Day (Continue... )
If using 7-Day Programming use previous steps for
every individual day.
You can also use these time saving functions. You must be in Set
Sched Programming Mode (Press Menu >> Press Set Sched)
for the following functions to work:
1) To copy ALL time periods and temperatures of current system and
day to ALL days, Press and Hold 2nd button down on left until the
Days and Time flash.
2) To copy ALL time periods (only times) for ALL days to the opposite
system (Heat to Cool / Cool to Heat), Press and hold the Glow in the
or
Dark Light button down until Set Time and Time flash.