Before First Use; Hob - Daily Use - Electrolux EKG20100OK User Manual

Table of Contents

Advertisement

Available languages

Available languages

5. BEFORE FIRST USE

WARNING!
Refer to Safety chapters.
5.1 Initial Cleaning
Remove all accessories from the
appliance.
Refer to "Care and cleaning"
chapter.
Clean the appliance and the accessories
before first use.
Put the accessories back to their initial
position.
5.2 Preheating
Preheat the empty appliance to burn off
the remaining grease.

6. HOB - DAILY USE

WARNING!
Refer to Safety chapters.
6.1 Ignition of the hob burner
Always light the burner
before you put on the
cookware.
WARNING!
Be very careful when you
use open fire in the kitchen
environment. The
manufacturer declines any
responsibility in case of the
flame misuse.
1. Push and hold the spark generator
button
2. At the same time turn the knob for
the hob counterclockwise to the
maximum gas flow position
push it down to light the burner.
3. Release the spark generator button
when burner lights but keep the knob
on this position for equal or less than
10 seconds to let the thermocouple
.
1. Set the maximum temperature.
2. Let the appliance operate for
approximately 1 hour.
WARNING!
Accessories can become
hotter than usual.
The appliance can emit an odour and
smoke. This is normal. Make sure that
the airflow is sufficient.
Let the oven cool down. Dampen a soft
cloth with warm water and a little mild
washing-up liquid and use this to clean
the oven cavity.
warm up. If not, the gas supply will
be interrupted.
4. Adjust the flame after it is regular.
WARNING!
Do not keep the knob
pushed for more than 15
seconds. If the burner does
not light after 15 seconds,
release the knob, turn it into
the off position and try to
light the burner again after
minimum 1 minute.
If after some tries the burner
does not light, check if the
crown and its cap are in the
correct position.
and
ENGLISH
13

Advertisement

Table of Contents
loading

Table of Contents