Makita DFJ212A Instruction Manual page 10

5. From the inside of the jacket/vest, place the ring
onto the fan unit and turn it clockwise until the triangle
marking is aligned with " II " marking.
2
► 1. Ring 2. Fan unit 3. " II " marking 4. Triangle mark-
ing 5. " I " marking
NOTE: When turning the ring, be careful not to move
the fan unit position. Keep the position of the loop on
the fan unit closest to the strip.
NOTE: Put the ring parallel to the fan unit. If not, you
may not be able to turn the ring smoothly.
NOTE: When you use filter set (optional accessory),
turn the ring until the triangle marking is aligned with
" I " marking. (the ring cannot be turned up to " II "
marking)
6. Pass the strip through the loop on the fan unit and
fasten the snap button.
2
► 1. Strip 2. Snap button
CAUTION:
Always use the strip and snap
button to secure the fan unit to the jacket/vest. If
the fan unit falls, it may cause an injury, or damage to
the fan unit.
7. Attach the other fan unit to the jacket/vest in the
same way.
1
3
4
5
1
8. Connect the power cable to the fan units.
► 1. Power cable 2. Cable holder 3. Zip fastener
NOTE: The zip fastener is not provided with the
jacket/vest without lining.
NOTICE:
Always connect the power cable to
both of the fan units. The fan does not operate if the
power cable is connected to one fan unit only.
9. Follow either instructions below depending on how
to store the battery when using the fan jacket/vest:
When storing the battery in the battery pocket or on
your belt
Pass the end of the power cable out through the hole
in the jacket's/vest's lining as shown in the figure (skip
this step if your jacket/vest does not have the lining).
Support the cable using the cable holder.
► 1. Hole in the lining 2. Power cable
10 ENGLISH
1
3
2
2
1