Advertisement
PolarChoice PC Sat-5/ PC Sat-12/ PC Sat-18 Microphones
Microphone Setup:
A. Hi
Pass
Select
Cardioid
Supercardioid
Hypercardioid
Omnidirectional
B. Polar
Pattern
Select
Figure 1: PC Satellite Controls
Antenna Guide
Attach Boss
Figure 2:
Bottom View
1) A. Select High-Pass switch position (see figure 1).
Flat (
): Normal response.
High Pass (
): minimum 5 dB reduction in sensitivity at 100 Hz.
B. Select preferred polar pattern (see figure 1).
C. Pushbutton Mode Select (see figure 1) -
"Push to Mute": In this mode, the audio output of the microphone is disabled (muted) when button is depressed.
Microphone resumes normal function when button is released.
"Push On/Off": In this mode, the audio output of the microphone is disabled when the pushbutton is depressed and
released. The microphone resumes normal function when the button is depressed and released again.
D. Power Up Mode Select (see figure 1) - This mode only functions when control (C) is set to "Push On/Off".
"Power Up On": In this mode, audio output of the microphone is enabled when power from the bodypack transmitter
is applied.
"Power Up Off": In this mode, audio output of the microphone is disabled when power from the bodypack
transmitter is applied.
2) Note: bodypack transmitter must have the "bodypack" button installed on the back of its' housing. The bodypack does
not ship with this part attached.
3) Insert bodypack into Satellite (see figure 3). "Bodypack" button inserts into opening on bottom plate. Push bodypack
into plate, and slide down as shown.
4) Carefully insert TA4F connector into bodypack (see figure 4).
5) Turn on bodypack transmitter & check for mic level.
6) Test mic in actual use situation, and set audio gain on bodypack transmitter for optimal gain through wireless system.
Note: battery door may be opened to access gain adjustment in bodypack, without removing bodypack from base (see
figure 4).
7) If desired, install antenna guide using screw provided (see figure 5). First drive in screw completely, then back it out
slightly, hook on antenna guide and screw it down. Orient antenna within guide to achieve vertical antenna polarization
(see figure 6).
C. Push
Button Mode
Select
D. Power
Up Mode
Select
TA4F
Cable
Base
Opening
Bodypack
Button
Figure 3: Installation of
Bodypack Transmitter
Figure 5: Antenna
Guide Installation
TA4F
Connector
Bodypack Transmitter
Battery Door
Figure 4: Bottom View
with Bodypack
Transmitter
Figure 6: Orientation
of Antenna with
Antenna Guide
Advertisement
