Using The Baby Monitor; Setting Up; Power On Or Off The Baby Unit; Power On Or Off The Parent Unit - Motorola VM482ANXL User Manual

3. Using the Baby Monitor

Please read these instructions carefully, and be aware that this baby monitor is
only intended as an aid. It is not a substitute for responsible adult supervision.
3.1

Setting Up

• Make sure that the Baby Unit and Parent Unit are both switched on.
• Place the Baby Unit in a convenient location (e.g. on a table) and point the
camera lens towards the area you want to monitor.
NOTE
Do not place the Baby Unit within reach of a child or baby! If there is
interference with the picture or sound, try moving the units to different locations,
and ensure that they are not close to any other electrical equipment.
If you place the Parent Unit and Baby Unit too close together, you may hear a
high pitched noise. This is not a fault. The units are designed to be operated at
some distance apart. So move the units further apart.
3.2

Power On or Off the Baby Unit

Slide the ON/OFF switch to the On position to turn on the Baby Unit.
The Power/Link indicator lights up in green.
Slide the Power ON/OFF switch to the Off position to turn off the Baby Unit.
The Power/Link indicator goes off.
3.3

Power On or Off the Parent Unit

Press and hold
up in green.
Press and hold
off.
NOTE
If you place the Parent and Baby Units too close together, you may hear a high
pitched noise. This is not a fault. The units are designed to be operated at some
distance apart, e.g. in separate rooms, so move the units further apart.
14
to turn on the Parent Unit. The Power/Link indicator lights
to turn off the Parent Unit. The Power/Link indicator goes
Using the Baby Monitor