Related Manuals for anko CF-6006N
Summary of Contents for anko CF-6006N
- Page 1 Massage Belt with Heat User Manual Model No.: CF-6006N Rev 1 Note: The specifications and/or components of this appliance are subject to change without prior notice.
-
Page 2: Table Of Contents
Warnings ................3 Important Safeguards ............3 Components ..............6 Features ................7 Operation Procedure ............7 Power supply ..............7 Massager Controller ............8 Massage Belt..............9 Cleaning the Massager ..........10 Completion and Storage ..........10 Troubleshooting ............. 11 Warranty Against Defect .......... -
Page 3: Warnings
1 Warnings Before using this appliance, read and follow all warnings and instructions in this manual, even if you are familiar with this product. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. - Page 4 Do not place this unit on other appliances, on uneven surfaces or where it could be subject to heat sources (e.g., radiators or stoves), direct sunlight, excessive dust. This Appliance should not be placed near a hot gas or electrical burner or placed in a heated oven.
- Page 5 The unattended use of heat by children or incapacitated persons may be dangerous. This product is Not to be used by very young children (0-3 years) Children under the age of three are not to use this appliance due to their inability to react to overheating.
-
Page 6: Components
3 Components Massage Belt with Heat Belt Extension Controller D.C. Output Plug D.C. Input Socket Power Supply: GQ24-120150- AA Page 6 of 12... -
Page 7: Features
4 Features Built in 4 vibration massage motors. • 3 pre-programmed massage modes. • • 2 levels of vibration intensity. Optional soothing heat therapy. • 30-minute Auto Off timer. • • Convenient Corded Remote controller 5 Operation Procedure NOTE: This appliance will automatically turn off after approximately 30 minutes of operation. -
Page 8: Massager Controller
5.2 Massager Controller On / Off Indicator Light On / Off Button Intensity Indicator Light Intensity Button Mode Indicator Light Mode Button Heat Indicator Light Heat Button On / Off Button: Press the On / Off Button to switch On and bring the •... -
Page 9: Massage Belt
Heat Button: With the Controller switched on (out of standby), press this • button and the Massager heater will start to heat on Maximum power. The Indicator light will illuminate bright indicating it is on Maximum power. Press this button again, and the Heater will reduce to Low power indicated by the indicator light dimming. -
Page 10: Cleaning The Massager
6 Cleaning the Massager CAUTION: DO NOT IMMERSE IN WATER OR LIQUID. Turn off and unplug from power supply prior to cleaning. • Do Not immerse the Massager or power supply in water, or any other • liquid. Spot Clean only with a soft, very slight damp sponge. •... -
Page 11: Troubleshooting
8 Troubleshooting Problem Cause Remedy Plug in power supply and Switch On at power point. If still no power, check the power point power supplied Power Not Switched On. checking with another appliance such as a table lamp. If no power to the power point, call Power. -
Page 12: Warranty Against Defect
9 Warranty Against Defect 12 Month Warranty Thank you for your purchase from Kmart. Kmart Australia Ltd warrants your new product to be free from defects in materials and workmanship for the period stated above, from the date of purchase, provided that the product is used in accordance with accompanying recommendations or instructions where provided.
Need help?
Do you have a question about the CF-6006N and is the answer not in the manual?
Questions and answers