Ozito JSW-6800 Instruction Manual page 5

6. CONTROLS CONTINUED
Adjusting the Cutting Speed
The cutting speed should be adjusted to match the material of the
workpiece. In general, use fastener speeds for softer materials.
1 For faster speeds, rotate the
variable speed dial to a higher
number.
For slower speeds, rotate the dial
to a lower number.
Adjusting the Cutting Action
The jigsaw has a pendulum action feature which enables the blade to
cut faster and more efficiently in thick and softer materials. See below
for a guide on choosing the correct setting.
1 To use the pendulum action,
rotate the pendulum action
selector anti-clockwise to a
higher setting.
2 To use standard cutting action,
rotate the pendulum action
selector clockwise to a lower
setting.
0 -
No pendulum action for fine clean cuts
on thin or hard materials
Small pendulum action for faster
1 -
cutting on hard materials
Medium pendulum action for faster
2 -
cutting on softer materials
Large pendulum action for fast cutting
3 -
along the grain on soft materials.
7. CUTTING
2
1
3
0
2
1
3
0
1 Ensure the correct
blade is inserted into
the blade lock and is
secure.
2 Mark your cutting line with a
pencil or attach the parallel
guide.
3 Place the base onto
the workpiece with
the blade away from
the edge.
4 Hold the jigsaw firmly ensuring
that your hands cannot slip
down onto the blade and start
the jigsaw by depressing the
on/off switch.
CAUTION! ENSURE HANDS AND FINGERS ARE KEPT
WELL AWAY FROM THE BLADE AND THE CUTTING
PATH AT ALL TIMES TO AVOID INJURIES.
5 Move jigsaw forward
with light pressure.
Allow the blade to
stop before lifting the
jigsaw away.
2
1
3
0
2
1
3
0
2 1
3
0
2
1
3
0
JSW-6800