Section 5- Optional Equipment; Am-Se - Straddle Extension Kit- Set-Up And Operation - JLG AM-19 Operators And Safety Manual Service & Maintenance Manual Illustrated Parts Manual

JLG
Lift SECTION 5 - OPTIONAL EQUIPMENT
JLG
Lift
5-1. OPTIONAL EQUIPMENT
The Accessmaster AM models are available with the
following optional equipment
• 110 Volt AC Model
• 220 Volt AC Model
• 12 Volt DC Model with 11 0 Volt Input Battery
Charger
• 12 Volt DC Model with 220 Volt Input Battery
Charger
• 22" x 22" Platform
• Step-in Molded Platform w/Swing-up Gate
• Tool Tray
• Fluorescent Tube Caddy
• Crane Hook
• Straddle Extension Kit
(Requires Straddle Adapter)
• Ladder for Straddle Extension
• Extra Power Pack (Battery, Charger & Case)
• Removeable Rear Swivel Locking Castor
Wheels
5-2. AM-SE - STRADDLE EXTENSION KIT-
SET-UP AND OPERATION
• · · · • Description
This sub-section contains instructions for installa-
tion of the straddle extension adaptor to both AC
and DC machines. Also included are instructions
for set -up and operation of the straddle extension
kit.
The AM-SE straddle extension kit increases the
versatility of the AccessMaster AM models by
providing a bridge for access to areas where
obstacles such as rows of seats, machines,
counters or stairwells are encountered. The dou-
ble-winch elevating system permits one man
setup and swivel casters allow the coupled con-
figuration to be easily maneuvered. The unit can
be quickly disassembled for compact storage.
The straddle extension provides clearance of up
to 48 inches (1.2m) and the length for caster
spacing is adjustable from 1 04 to 128 inches
(2.6m to 3.3 m). The AccessMaster AM models
are fully operational at full rated capacity when
used in combination with the straddle extension.
•. Straddle Adaptor Wiring Kit
AC & DC MODELS
The straddle wiring kit for both the AC & DC
(AM) models includes the following parts:
1. One (1) wiring harness with two (2) female -
three (3) prong (twist-lock) connectors on one
end which are wired together into three (3) 16
gauge wires - Red, White and Green -two with
fork terminals and one with butt splice (14 - 16
ga.) terminal, ready for connection in the AC
control box.
2.
Two (2) Spring Clamps.
3.
Four (4) #10 x 1/2" long self-tapping screws.
4. One (1) 3/8" I.D.\ 1/2" O.D grommet.
To install wiring kit, proceed as follows;
1.
Before unplugging AC unit power cord or dis-
connecting the DC unit power connector
(at
battery box),
set-up machine- i.e. install outrig-
gers and level machine. Raise the platform
approximately three or four feet while standing
outside platform on floor, this will allow access
to the base frame area under platform.
-JLG
Lift-
5-1