Wood Trim - Electrolux E24WC48EPS Use & Care Manual

Electrolux e24wc48eps: user guide
Hide thumbs Also See for E24WC48EPS:
Table of Contents

Advertisement

WINE RACKS WITH WOOD TRIM
Your Electrolux wine cooler is equipped with a natural wood trim on the wine racks
for appearance and durability. The wood trim has been coated at the factory with a
clear vinyl sealer, which will adequately protect the wood in normal usage.
CA
CAUTION
CA
UTION
UTION
UTION
CA
CA
UTION
!
To prevent permanent damage to the inner liner of your wine cooler , the wine rack
wood trim MUST be removed from the unit for staining and/or finishing. Allow stain/
finish to dry thoroughly (at least 24 hours per coat) in accordance with the stain/finish
manufacturer's instructions prior to re-installing the wood trim inside the cabinet of the
wine cooler . Failure to do so may cause the inner liner of the unit to have a permanent
odor, which is not covered by the warranty.
You have 3 options regarding the wood trim on the wine racks.
(1) You can leave as is, (2) add a final finish coat or (3) you may stain the wood
trim. The final finish coat was not applied at the factory so that the wood trim could
be stained. YOU CANNOT STAIN THE WOOD TRIM ONCE YOU APPLY THE
FINAL FINISH. Review the following guidelines when staining and or sealing the
wood to ensure proper adhesion and durability of the finish.
To add a final finish coat:
1
Remove five racks with wood trim from unit, see RACK REMOVAL/
INSTALLATION.
2
Remove screws securing wood trim to racks.
3
Lightly scruff sand the molding with 280 grit 3M Tri-M-Ite® sand-paper.
4
Remove sanding dust with a clean, dry cloth.
5
Apply a thin coat of a clear protective finish; the factory-applied seal is
compatible with virtually all finishes. A low odor, water clean up, quick drying
finish such as Minwax Polycrylic® is recommended. Follow container label
for directions.
6
Lightly sand and reapply if desired.

Wood Trim

9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents