Hardware Installation; Hardware Uninstallation - Advantech USB-4750 User Manual

Advantech 32-channel isolated digital i/o usb module user manual

Hide thumbs Also See for USB-4750:

Table of Contents

2.3 Hardware Installation

Note:

Make sure you have installed the software driver

before you install the module (please refer to Sec-

tion 2.2 Driver Installation)

After the DLL driver installation is completed, you can now go on to

install the USB-4750 module in any USB port that supports the

USB 1.1/2.0 standard, on your computer. It is suggested that you refer to

the computer's user manual if you have any doubts. Please follow the

steps below to install the module on your system.

Step 1: Touch the metal part on the surface of your computer to neutral-

ize the static electricity that might be in your body.

Step 2: Plug your USB module into the selected USB port. Use of exces-

sive force must be avoided; otherwise the module might get damaged.

Note:

In case you installed the module without installing the

DLL driver first, Windows 2000/XP will recognize your

module as an "unknown device" after reboot, and will

prompt you to provide necessary driver. You should

ignore the prompting messages (just click the Cancel

button) and set up the driver according to the steps

described in Section 2.2 Driver Installation.

After your module is installed, you can configure it using the Advantech

Device Manager. The Device Driver's Manual can be found at:

Start\Programs\Advantech Automation\Advantech Device Man-

ager\Device Driver's Manual

Though the Advantech USB modules are hot swappable, we still recom-

mend you to follow the hardware un-installation procedure to avoid any

unpredictable damages to your device or your system.

Step1: Close the applications of the USB module.

Chapter 2

Table of Contents