Electrolux EIMED55I Use And Care Manual page 9

4. Select the appropriate cycle and
settings for each load.
NOTE
Over-drying can cause wrinkles, shrinkage, lint,
harshness and a build up of static electricity.
Turn the cycle selector knob in either direction
to select the cycle desired. The estimated dry-
ing time for Auto Dry cycles or the actual dry-
ing time for Time Dry cycles will be displayed.
A suitable drying temperature, dryness level
and options will automatically be indicated for
the cycle selected. See the "Dryer Settings
Chart" for more details.
To change the drying temperature and dryness
level, press the temperature and dryness but-
tons to scroll to the desired settings.
To select or delete an option, press the button
for that option. The indicator will be illuminated
when the option has been selected. The indi-
cator will no longer be lighted when the option
has been deleted.
NOTE
If a setting is not available for the cycle selected,
the indicator will not light.
Adjustments made to a cycle will be remembered
and recalled each time that cycle is selected in
the future.
To return to factory settings, press the tem-
perature and dryness buttons at the same
time and hold for 5 seconds.
5. Start the cycle.
Close the door and press start to begin the
cycle. The dryer will not operate with the door
open. To interrupt the cycle, press pause;
press start to resume the cycle. Press cancel
to stop the cycle.
If changes to the cycle, temperature, dryness
level or options are attempted after the cycle
starts, the lights will blink and a signal will beep.
To change the cycle once the cycle has be-
gun, press cancel and select a new cycle. To
change the temperature, dryness level or op-
tions once the cycle has begun, press pause
and make the new selections.
A signal will sound at the end of the cycle if
the chime option has been selected. When the
cycle ends, remove the items promptly and
hang or fold.
Operating Instructions
IMPORTANT
Clean the lint fi lter after every load.
FILTER
will be displayed at the end of the cycle
to remind you to remove lint from the fi lter.
CLEAN
9