How To Load Software For Mpeg P.w.board - Sanyo RB-7201 Service Manual

HOW TO LOAD SOFTWARE FOR MPEG P.W.BOARD

a. Push the power button to ON.
b. Push the OPEN/CLOSE button to open the tray.
c. Place the CD-R disc into the tray for updating. Then push the
OPEN/CLOSE button to close the tray. (Do not press PLAY key.)
If tray is done in close excluding OPEN/CLOSE key. It does not
become update mode.
d. The under mentioned display appears to the screen READING
doing and about 6 seconds later.
Display on "FL"
UPDATE DSC
Display on screen.
Detect firm update disc
to start updating : press PLAY key.
to quit : press OPEN key.
Cancel is good at Update by pushing OPEN/CLOSE.
After disk is inserted, keys other than OPEN/CLOSE key are
disregarded.
Attention
1. Main power should not be cut off until the "STANDBY LED" lights
up.
2. When the main power is cut off during installing, follow the
procedure as below.
A. When the main power is cut off before or after appearing the
letters on the screen as mentioned at procedure #c,
a. Plug out the power cord and plug it in again.
b. Confirm that the "STANDBY LED" lights up.
c. Push "OPEN/CLOSE" key.
d. Carry out the rewriting procedure from procedure #b.
B. When the main power is cut off within 9 seconds before
completing the procedure #d,
a. Plug out the power cord and plug it in again.
b. Confirm that the "STANDBY LED" lights up.
c. Push "OPEN/CLOSE" key.
d. Carry out the rewriting procedure from procedure #b.
In case the "STANDBY LED" does not light up even if the power
cord is plugged out and in several times, the "FLUSH
MEMORY" might get damaged. Please change the "FLUSH
MEMORY" or the "MPEG PWB" and carry out the rewriting
procedure from restart.
e. Press PLAY key then updating.
Display on "FL"
UPDATING
Display on screen.
Updating firmware -- Please wait
Your player will restart
automatically when complete.
It is not possible to discontinue on the way when Update begins.
f. After 40 seconds, the picture will become off. Then STANDBY
LED light. Update complete. POWER key press and OPEN/
CLOSE key press and take out the CD-R.
g. Execute initializing.
h. Using remocon, press on SET UP , Parental , 460076 , ENTER
and SET UP.
i. Initializing of SET UP complete.
Version CD-R part code
UK,XE 0PRADD7103A29
AU 0PRADD7103A4E
SS 0PRADD7103A3E
CA 0PRADD7103A1EA
3. When "READING" or "0:00" appears on the FL,
a. Plug out the power cord and plug it in again.
b. Confirm that the "STANDBY LED" lights up.
c. Push "OPEN/CLOSE" key.
e. Carry out the rewriting procedure from inspection #b.
- 41 -
Region No. Description
2 9 LANG.
4 English
3 English
English
1