Table of Contents
Advertisement
9 INSTALLATION
The following chapters describe the device's installation phases.
Please read this manual thoroughly before proceeding with the installation.
For the installation you need:
• Scissors and a wire stripper.
• Flat-tip and Phillips screwdriver (medium).
• A 12mm hole saw for the hole, if required, to pass the wiring cable pass from the engine
compartment to the passenger compartment.
• 5mm drill bit for the assembly screws.
• Plastic cable ties.
• Pliers for cable terminals.
• Square tip pliers.
• PC connected to Internet in order to program the device.
The installation requires the following phases:
1. Reading of the installation and user manual.
2. Planning and positioning of the device.
3. Power supply connections.
4. Connection of the wiring to the device.
5. Configuration.
20
The installation must be performed by qualified personnel only.
The installation must be carried out following the indications
provided in the specific installation sheet for the vehicle you are
working on.
Advertisement
Table of Contents
