Table of Contents
Advertisement
2. If there is no disc inside the CD compartment, the LED TRACK DISPLAY with show "no". Grip
the "OPEN" mark on the CD Door and pull gently to open it.
3. Load a disc into the compartment with the printed side facing you.
4. Gently close the CD DOOR. The Karaoke System begins to read the disc. The LED TRACK
DISPLAY will show the total number of tracks.
5. Press
PLAY/PAUSE button to play disc. (If no disc is recognized, "no" or "Er" will be
displayed).
PLAY/PAUSE MODE
1. To start playing, press the
the PLAY/PAUSE INDICATOR will light.
2. To temporarily stop playing, press the
PLAY/PAUSE INDICATOR will flash.
3. To resume play, press
4. Use the MASTER VOLUME CONTROL to increase or decrease the speaker sound.
Notes:
•
If a CD+G disc is detected, the CD+G indicator will also turn on.
•
To see the CD+G lyrics, connect the provide A/V cable an external TV/monitor (not included).
STOP MODE
If the STOP button is pressed in the course of playing, the disc will cease to play. The total number of
tracks will be shown on the LED TRACK DISPLAY.
SKIP/SERACH (For both CD and CD+G discs)
1. In stop mode, you can skip up or down to a specific track number by pressing the / SKIP
buttons.
2. While the selected track is displayed, press the
3. During the PLAY mode, you can skip down or up to a specific track number by pressing the /
SKIP buttons respectively.
4. [For CD only]
fast-rewind search through the current track.
1. To repeat the current track, press the REPEAT button once. The REPEAT INDICATOR will flash.
The track will continue to play until the repeat function is turned off.
2. To repeat all the tracks, press the REPEAT button twice. The REPEAT INDICATOR will light up
steadily. All the tracks on the disc will be played repeatedly.
3. To clear the repeat function, press the REPEAT button again. The REPEAT INDICATOR will turn
off.
Use this button to program and play back songs in a pre-selected order.
Note: Programming can be done in the stop mode only.
1. Press the PROGRAM button. The PROGRAM (PROG) INDICATOR will light up.
2. Press the / SKIP buttons forward or back to select a desired track number.
3. Press PROGRAM button to confirm entry.
4. You can repeat the steps 2 & 3 up to a maximum of 20 tracks at which the LED DISPLAY will
show "FU".
5. Press
PLAY/PAUSE button when you have completed programming to start playing. You are
now ready to start singing along.
6. Press STOP button twice or open the CD COMPARTMENT COVER to clear all the programmed
PLAY/PAUSE button once, the first track "1" will be displayed and
PLAY/PAUSE button again.
When music is playing, hold the / SKIP buttons to fast-forward or
CD OR CD+G REPEAT OPERATION
CD OR CD+G PROGRAM OPERATION
PLAY/PAUSE button, the LED TRACK DISPLAY and
PLAY/PAUSE button to start playing.
10
Advertisement
Table of Contents
