Product Information; Troubleshooting - Philips 4000 Series User Manual

6
Product
information
Note
•
Product information is subject to change without prior
notice.
Ampli er
Rated Output Power
Tuner (FM)
Tuning Range
Tuning Grid
Sensitivity
- Mono, 26 dB S/N Ratio
Total Harmonic Distortion
Signal to Noise Ratio
USB charging port
USB charging
General information
AC Power (power
adaptor)
Operation Power
Consumption
Standby Power
Consumption
Dimensions
(W x H x D)
Weight
(Main unit)
700mW RMS
87.5-108 MHz
50 KHz
<22 dBf
<3%
>50 dBA
5V 1A
Brand: Philips
Model: AS150-
050-AE150
Input: 100-240V~
50/60 Hz; 0.7A
Output: 5V 1.5A
<7.5 W
<1 W
110 x 110 x 75 mm
224.6 g
7

Troubleshooting

Warning
•
Never remove the casing of the product.
To keep the warranty valid, never try to repair
the device yourself. If you encounter problems
when using this device, check the following
points before requesting service. If the problem
remains unsolved, go to the Philips webpage
www.philips.com/support. When you contact
Philips, make sure that the device is nearby
and the model number and serial number are
available.
No power
•
Make sure that the AC power plug of the unit
is connected properly.
•
Make sure that there is power at the AC outlet.
No sound
•
Adjust the volume.
No response from the unit
•
Disconnect and reconnect the AC power plug,
then turn on the unit again.
Poor radio reception
•
Keep the clock radio away from other
electronic devices to avoid radio interference.
•
Fully extend and adjust the position of the
antenna.
Alarm does not work
•
Set the clock/alarm correctly.
Clock/alarm setting erased
•
Power has been interrupted or the power
plug has been disconnected.
•
Reset the clock/alarm.
•
Replace the backup batteries.
EN 7