5: On-Board Relays; 6: System Settings; 7: Timers; 8: Daylight Savings - Honeywell Fire-Lite Alarms MRP-2001 Instruction Manual

Read Status
Pressing 1 for Release 1 or 2 for Release 2 will display the cross-zoning, if any, for the selected
Releasing Circuit as illustrated in the following screen:
The Cross Zone Release screen displays the zones that have been cross-zoned. In this example,
Zone 1 is cross-zoned with Zone 4.
4.15.5 On-Board Relays
Pressing 2 while viewing Read Status Screen #2 will display the following screen:
To view the information about a relay, press the number key corresponding to the desired relay. The
following screen will be displayed:
4.15.6 System Settings
Pressing 3 while viewing Read Status Screen #2 will display the following screens:
FUTURE USE
TROUBLE REMIND
CHARGER DISABLE
The operator can view the system settings options that have been programmed into the FACP.
4.15.7 Timers
READ STATUS
Pressing 1 while Read Status Screen #3 will display the following screens:
1=TIMERS
2=DAYLIGHT SAVINGS
3=HISTORY
Read Status Screen #3
These screens allow the operator to view the various timer settings.
4.15.8 Daylight Savings
Pressing 2 while Read Status Screen #3 will cause the following screens to be displayed:
These screens allow the operator to view settings that have been programmed for Daylight Savings
Time.
MRP-2001 Series Manual — P/N 53040:H 1/26/2017
SYSTEM SETTINGS
NO
NO
TIMERS
SOAK 1
SOAK 2
WATERFLOW DELAY
DAYLIGHT SAVINGS
ENABLED
START MONTH
START WEEK
CROSS ZONE REL 1
X 1 4
NONE
NONE
Cross Input Zone Screen
ON-BOARD RELAYS
1=RELAY 1
2=RELAY 2
3=RELAY 3
RELAY #
TYPE ALARM
LATCHING
SYSTEM SETTINGS
FACTORY BANNER
TIMERS
10 MIN
AC LOSS DELAY
10 MIN
0S
DAYLIGHT SAVINGS
YES
END MONTH
MAR
END WEEK
WK 2
Operating Instructions
NO
SYSTEM SETTINGS
CANADIAN OPTION
SEC ANN ENABLE
2 HR
NOV
WK 1
NO
NO
85