Motion Control - Energetics POWER RUN 9.9 HRC Manual

USING THE CHEST BELT HEART RATE MONITOR (optional feature dependant on model purchased):
For proper operation, the chest belt should be worn across the front of your body just below the chest line as
shown in the drawing. To ensure a proper operation the chest belt needs to be moisturized, please make the 2
rubber pads under the chest belt wet prior to exercising.

MOTION CONTROL:

Walking belt speed can be increased, decreased or stopped using the Motion Control sensors on the
handlebars. To do this follows the instructions below:
1．Press the MOTION CONTROL button on the console to switch the motion control functions on and off:
When the LED light is ON the MOTION CONTROL is active.
•
When the LED light is OFF the MOTION CONTROL is off.
•
2．After switching on the MOTION CONTROL wave your right hand approximately 10 cm above the motion
sensor on the right handle bar to increase the speed. The sensor will sound one short BEEP per scan and
speed up by 0.1 km/h per BEEP. Holding your right hand approximately 15 cm above the right sensor
constantly results in the sensor sounding one long BEEP per second and speeding up by 0.8 km/h per second.
(2) Use right sensor to speed up.
Strap chest belt across the front below the chest line.
9