Cisco 8800 Series Hardware Installation Manual page 65

Powering on the Router
• Check that the power switch is set to the STANDBY (0) position on the power tray.
• The HVAC or HVDC power sources are rated for 30A maximum input current.
Procedure
Step 1
Choose your power supply (HVAC or HVDC) and use a Saf-D-Grid power cable to connect to the power
supply tray.
Step 2
For HVAC input, connect a Saf-D-Grid AC power cable to the Saf-D-Grid receptacle.
Figure 47: HV Power Tray
1 Rear
Connect HVAC/HVDC Power Supply to Power Source
2 Front
Hardware Installation Guide for Cisco 8800 Series Routers
59