Tips & Troubleshooting - Gallagher S10 Instructions Manual

TIPS & TROUBLESHOOTING
• Install energizer where it can get plenty of sunlight.
• Install solar energizers on a post above the ground.
• Keep solar panel surface clean - periodically use a soft cloth with water and a
mild detergent.
• Test voltage on the fence using a Gallagher Fence Volt Meter (G50301).
• Turn energizer off before handling fence or battery connections.
Problem
Indicator flashing red
Indicator flashes red
twice when turned on
then stops
No voltage on fence
10
Solutions
• Ensure energizer is getting enough sun.
• Turn energizer OFF for 3 days, leave in the
sun to charge battery.
• Remove battery and use a 6 V 1.2 A
charger to charge battery.
• Perform above steps.
• Replace battery.
• Check energizer isn't faulty;
- disconnect from fence and earth
- measure across fence and earth
terminals with a Gallagher Fence Volt
Meter
- if less than 5 kV return energizer for
service
- if more than 5 kV the fault is with the
fence or earth system.