Table of Contents
Advertisement
Appendix D
ARMC Card Flash Utility
The WinFlash.exe program is a recovery tool that can be executed from a remote
client system located on the same network as the ARMC card. You can use it to recover a
failed flash attempt.
To run the ARMC Flash Utility program, double left click on the WinFlash.exe icon.
Note:
You must physically set the ARMC card you want to recover into Recovery Mode. To do
this, simply short pins two and three on jumper JP6 on your ARMC card.
Note:
Your ARMC card must be write enabled before you can flash an image to it. Confirm
that pins one and two on jumper JP2 are shorted on your ARMC card.
Note:
The firmware upgrade process is a crucial operation. Make sure that the chances of a
power or connectivity loss are minimal when performing this operation.
Button
Description
Card Settings
Left click the Card Settings button to configure the ARMC card parameters.
Note:
Start Flashing
Left click the Start Flashing button to begin flashing the firmware image to your ARMC
card.
Done
Left click the Done button to end the ARMC Flash Utility.
Note:
You must configure the card parameters before you can start flashing your ARMC card's
firmware.
ARMC Flash Utility
You must configure the card parameters before you start flashing.
Cont'd
Appendix D : ARMC Flash Utility 125
Advertisement
Table of Contents
