68
Upgrading the processor
This section explains the procedures for removing and installing the
processor and heat sink fan (HSF) assembly.
Processor configuration guidelines
The mainboard supports up to two Intel® Xeon™ processor 5500
series. You have the option to upgrade the default processor or install
a second one for a dual-processor configuration.
Observe the following guidelines when replacing or installing a
processor.
•
The CPU 1 socket must always be populated. If no processor is
installed in this socket, the system will fail to boot.
•
Before removing a processor, make sure to back up all important
system files.
•
When installing a second processor, make sure it has same
stepping and frequency specifications as the default processor.
•
Handle the processor and the HSF assembly carefully. Damage to
either may prevent the system from functioning properly.
Note: A long-nosed screwdriver is needed to remove/install the
HSF assembly
To upgrade the default processor:
1
Perform the pre-installation instructions described on page 41.
2
Lay the server on its side (components showing).
.
3 System upgrade