Setting A System Password - Acer Altos G540 M2 Series User Manual

126
Parameter
Supervisor
Password Is
User Password Is
Set Supervisor
Password
Set User
Password
Password On
Boot
Security Mode
for PWR/RST
Button
Clear Case Open
Status

Setting a system password

1 Use the up/down keys to select a password parameter (Set
Supervisor Password or Set User Password), then press Enter.
A password box will appear.
2 Type a password then press Enter.
The password may consist of up to six alphanumeric characters
(A-Z, a-z, 0-9).
3 Retype the password to verify the first entry then press Enter
again.
4 Press F10.
5 Select Yes to save the new password and close the Setup Utility.
Description
This parameter indicates whether a
supervisor password has been assigned.
This parameter indicates whether a user
password has been assigned.
Press Enter to configure the supervisor password.
Press Enter to configure the user password.
Select Enabled to activate security check
during POST.
Enables or Disables the Security Mode for
PWR/RST Button.
Press Enter then select whether to enable
or disable the clear case open status at
next boot function.
4 System BIOS
Option
Clear
Enabled
Clear
Enabled
Disabled
Enabled
Disabled
Enabled