Parameter
Supervisor
Password Is
User Password Is
Set Supervisor
Password
Set User
Password
Password On
Boot
TPM Support
Setting a system password
1
Use the up/down keys to select a password parameter (Set
Supervisor Password or Set User Password), then press Enter.
A password box will appear.
2
Type a password then press Enter.
The password may consist of up to six alphanumeric characters
(A-Z, a-z, 0-9).
3
Retype the password to verify the first entry then press Enter
again.
4
Press F10.
5
Select Yes to save the new password and close the Setup Utility.
Description
This parameter indicates whether a
supervisor password has been assigned.
This parameter indicates whether a user
password has been assigned.
Press Enter to configure the supervisor password.
Press Enter to configure the user password.
Select Enabled to activate security check
during POST.
Enable/Disable Trusted Platform Module
support
73
Option
Clear
Enabled
Clear
Enabled
Disabled
Enabled
Disabled
Enabled