Acer P5206 Series User Manual page 38

28
User Password
•
•
•
•
•
•
•
Administrator Password
You can enter "Administrator Password" when the "Enter
Administrator Password" or "Enter Password" dialogue box is
displayed.
•
•
If you forget your administrator password, do the following
to retrieve the administrator password:
•
•
Lock User Startup Screen
•
Selecting "On" enables the function. The projector can output
a VGA signal when it is in standby mode and the VGA IN (or
VGA IN 1) and VGA OUT sockets are correctly connected to the
devices.
VGA OUT
Press to set up or change "User Password".
Use the numerical keys on the remote control to set the
password and press "MENU" to confirm.
To delete the digits, Press
Enter the password again when you see "Confirm
Password" displayed.
The password should be 4~8 digits in length.
If you select "Request password only after plugging
power cord", you are requested to input the password
every time the power cord is plugged.
If you select "Always request password while projector
turns on", you are requested to input the password every
time the projector is turned on.
Press to change "Administrator Password".
The factory default of "Administrator Password" is
"1234".
Enter the unique 6-digit "Universal Password" which is
printed on the Security Card that came with your
projector. This unique password will be accepted by the
projector no matter what the administrator password is.
If the Security Card is lost, please contact your local Acer
service center.
The default value is "Off". If it is "On", you cannot
change the startup screen arbitrarily.
Enabling this function slightly increases the standby
power consumption.
.