Husqvarna ST 324 Operator's Manual page 20

Hide thumbs Also See for ST 324:
Table of Contents

Advertisement

Available languages

Available languages

2. Remove the tensioner spring (A) attached to the
drive belt tensioner arm (B).
E
G
B
A
J
3. Remove the return spring (C) holding the swing
plate (D) in place.
4. Remove the arm bolt (E) and drive belt tensioner
arm.
5. Remove the pulley bolt (F), engine pulley (G) and
drive belt (H) from the engine.
6. Remove the top bolt (I) holding the swing plate to
the frame
7. Pivot and hold the swing plate away from the
product and remove the drive belt from the drive
pulley (J).
To install the drive belt
1. Pivot and hold the swing plate (D) away from the
product.
E
G
B
A
J
2. Put the drive belt (H) onto the drive pulley (J).
Note:
Make sure that the drive belt is routed in
the drive pulley groove properly before you lower
the swing plate.
3. Install and tighten the top bolt (I).
4. Put the drive belt in the grove of the engine
pulley (G) before installing on the engine shaft.
20
F
H
I
C
D
F
H
I
C
D
5. Install the pulley bolt (F) and attach the engine
pulley on the engine. Tighten the pulley bolt
(30-35 Ft. Lbs. / 41-47 Nm).
6. Install the drive belt tensioner arm (B) and tighten
the arm bolt (E) on the engine.
7. Install the return spring (C) on the swing plate.
8. Install the tensioner spring (A) on the tensioner
arm.
9. Operate all controls to make sure that the drive
belt is installed correctly and that all components
are moving correctly.
To install the belt cover
1. Install the belt cover (B) on the frame (C) and
tighten the two screws (A).
C
2. Install the discharge chute.
To remove the auger belt
1. Remove the 5/16'' nut and the cable cover (E)
from the frame.
A
E
2. Remove the top 5/16'' bolts and lower ¼'' bolts
(D) from the 2 sides of the frame. Do not discard
the bolts.
3. Loosen but do not remove the lower 5/16'' bolts
(C) on the 2 sides of the frame.
A
B
B
C
D
1674 - 004 - 18.05.2021

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

St 327St 330

Table of Contents