Vitek VT-1333 Manual Instruction page 6

•
•
•
•
•
•
•
Note: During the first operation some smell from the
heating element is possible, this is normal.
•
•
•
•
•
•
IMPORTANT: do not keep the plates on the same area
of the hair lock for more than 2 seconds.
•
•
T-1333_70x130.indd 6
ENGLISH
Use the unit only on healthy undyed and not permed
hair or use it along with special hair straightening
products.
If your hair has been dyed or permed, use the unit
rarely.
For the best results the hair should be clean and dry.
Open the hair straightener moving clamp (1).
Put the unit on a flat steady and heat-resistant sur-
face.
Insert the plug into the mains socket, the «OFF» sym-
bols will appear on the display (5).
Switch the unit on by pressing and holding the on/
off button (2), the default heating plates tempera-
ture «190°С» will be flashing on the display (5) and
the heating scale will appear on the left side of the
display (5).
If necessary, set the required heating plates tempera-
ture by pressing the buttons (3).
Hair type
Damaged, colored,
bleached, fine
Normal
For professional styling
When the heating plates reach the set temperature,
the temperature digital indications and the heating
scale on the display (5) will be glowing constantly.
Divide combed hair into locks of equal width (about
5 cm).
Place the hair lock between the plates (4).
Hold the unit by its handle and press the plates (4)
together.
Slide the heating plates (4) with little force to the
hair tips.
After that start straightening the next hair lock.
Cool your hair down before final styling or applying
hair spray.
Temperature
from +150°С to +180°С
from +180°С to +210°С
from +210°С to +230°С
6
8/27/20 11:24