Removing The Hard Disk Drive; Removing The Intrusion Alarm Cable Module - Acer Veriton 3500G Service Manual

3. Disconnect the floppy disk drive cable and the floppy disk drive power connector, then remove the
diskette drive from the housing
.

Removing the Hard Disk Drive

1. See "Removing the Housing" on page 98. (Remove the left panel only)
2. Disconnect the hard disk drive IDE cable from the main board and then remove the four screws that hold
the hard disk drive to the disk frame. Set the screws aside.
.
3. Detach the hard disk drive power connector and hard disk drive IDE cable from the hard disk drive, then
detach the disk drive from the drive frame
.

Removing the Intrusion Alarm Cable Module

1. See "Removing the Housing" on page 98. (Remove the left panel only)
2. Disconnect the cable as shown here, remove the one screw here, and then detach the intrusion alarm
cable module from the housing.
Chapter 3 103