Table of Contents
Advertisement
Parameter
Video Off Option
Video Off Method
Modem Use IRQ
HDD Power Down
Soft-off by PWR-BTTN
After PC Power Lost
Power On by Ring
Wake-Up by PCI Card
Resume by Alarm
Chapter 2
Description
This item is to control the mode in which the
monitor will shut down.
Always On: Always keep the monitor on.
Suspend --> Off: During suspend mode, the
monitor will shut down. Susp, Stby --> During
suspend or standby mode, the monitor will shut
down. All Modes --> Off: The monitor is turned
off during doze, standby or suspend mode.
This item determines the manner in which the
monitor is blanked.
V/H SYNC+Blank: This selection will cause the
system to turn off the vertical and horizontal
synchronization ports and write blanks to the
video buffer. Blank Screen: This option only
write blanks to the video buffer. DPMS
Supported: Initial display power management
signaling.
This setting names the interrupt request (IRQ)
line assigned to the modem (if any) on your
system. Activity of selected IRQ always
awakens the system.
If HDD activity is not detected for the length of
time specified in this field, the hard disk drive will
be powered down while all other devices remain
active.
This feature allows users to configure the power
button function.
This item specifies when your system reboot
after a power failure or interrupt occurs.
When enabled, any fax/modem activity wakes up
the system from suspend mode.
Use PCI Wake-up system. PCI must meet PCI
2.2 specification.
Use this option to set the date and time for your
computer to boot up.
Date (of month) Alarm* - Indicate the month for
system to boot up. Set it to 0 if you want to boot
up everyday.
Time (hh:mm:ss) Alarm* - Indicate the hour,
minute and second for system to boot up.
Options
Always On
Suspend Off
Susp, Stby --> Off
All Modes
V/H SYNC+Blank
Blank Screen
DPMS Supported
3, 4, 5, 7, 9, 10, 11, AUTO.
Disabled
1~15 Mins
Instant Off: The power button
functions as a normal power-
on/-off button.
Delay 4 Sec.: When you press
the power button, the
computer enters the suspend/
sleep mode, but if the button is
pressed for more than four
seconds, the computer will be
turned off.
Power Off
Power On
Last State
Disabled
Enabled
Disabled
Enabled
Disabled
Enabled
*Set Resume by Alarm to
Enable, then press "Enter" to
show the range of Date and
Time Alarm.
31
Advertisement
Table of Contents
