System Disassembly; Chapter 3 System Disassembly; Disassembly Tools; Stages Of The Disassembly Process - Acer Aspire 4332 Service Manual

System Disassembly

This chapter provides step-by-step instructions on how to disassemble the computer for maintenance and
troubleshooting purposes.

Disassembly Tools

In performing the disassembly process, you will need the following tools:
Wrist-grounding strap and conductive mat for preventing electrostatic discharge
•
Philips screwdriver
•
Flat screwdriver
•
Plastic flat-blade screwdriver
•
Plastic tweezers
•

Stages of the Disassembly Process

The disassembly process is divided into three stages:
1. External modules disassembly
2. Main unit disassembly
a. Upper case disassembly
b. Lower case disassembly
c. LDC module disassembly
IMPORTANT: The disassembly procedure described in this chapter is a gradual process, as illustrated in the
flowcharts preceding each disassembly stage section. This means that users need to observe
the instructions in a step-by step manner. To illustrate, if you want to remove the mainboard,
you must first remove the keyboard, then disassemble the inside assembly frame in that order.
Failure to observe the gradual process may result in component damage.
NOTE: To reinstall the system components and assemble the unit, perform the disassembly procedures in
reverse.

Equivalent Torque Values

Torque values indicated in this chapter are expressed in kgf-cm (kilogram force-centimetre). For equivalent
values in in-lb (inch-pound force) and N mm (newton millimeter), refer to the table below.
kgf-cm in-lb
1.6 1.39
3.0 2.60
Acer Aspire 4732Z/4332 Service Guide
N mm
156.93
294.25
Chapter 3
25