Hillrom Welch Allyn 52100 Mounting Instructions

Mat. No. 1202590, 80027531 ver A
Revision Date: 2020-12
Choose the mounting method best suited to mounting surface type:
To affix unit to a dry, clean, firm nonporous surface (such as
sheetrock) use double-sided tape:
1. Attach 2 pieces of double-sided tape to White Base, keeping outer
release liner in place. Select location on wall.
CAUTION Take particular care to properly locate the
unit at FIRST contact of tape to wall.
2. Remove release liners and press unit firmly against wall in exact
position desired.
3. If necessary, to relocate: Remove from wall by prying under rear
of White Base. Then remove old tape and apply new double-sided
tape (1/16" thick) such as 3M 4466W or equivalent.
Models 52100 and 52101 Specula Dispensers
OR To affix unit to a rough, porous surface (such as vinyl
wallpaper) use screws:
1. Mark desired location for top of unit on wall. Measure
down 4" to mark top screw location. Measure down 3" to
locate lower screw.
2. Drive the two screws provided into the wall, leaving
about 1/8" behind the screw head. Depending on the
mounting surface, alternate screws may be needed.
3. Mount unit by fitting the round holes in the rear of
White Base over screw heads on the wall. Then push
downward on unit to secure it to wall.
(over)
Welch Allyn
Mounting Instructions
®