Ann-Rly Options Screen; Ann-Audio Options Screen; Ann-Sec Enable - Honeywell NOTIFIER SFP-5UD Series Manual

Programming

ANN-RLY Options Screen

PROGRAMMING
1=ANN-S/PG OPTIONS
2=ANN-80 OPTIONS
3=ANN-RLY OPTIONS
ANN-BUS Screen #2
The N-ANN-RLY module provides ten Form-C relays which can be programmed for various functions. The initial screen displays
Relays 1 through 3. Pressing the down arrow key will display the remaining relays for this module.
To program any of the N-ANN-RLY relays, while viewing the appropriate ANN-RLY Option screen, press the number key correspond-
ing to the relay to be programmed. Following is a list of the available programming options for each relay:
• General Alarm
• General Trouble
• General Supervisory
• AC Loss
• Waterflow Delay
• Input Zone 1
• Input Zone 2
• Input Zone 3
• Input Zone 4
• Input Zone 5
• Input Zone 6
• Input Zone 7
• Input Zone 8
• Input Zone 9
• Input Zone 10
• Silenceable Alarm
• Not Assigned

ANN-AUDIO Options Screen

PROGRAMMING
1=ANN-AUDIO OPTIONS
ANN-BUS Screen #3
This screen shows the Input Zone that has been assigned to be the All-Call Zone. In this example, Zone 1 is the All-Call Zone. The All-
Call Zone can be changed by pressing the 1 key while viewing the ANN-AUDIO Options Screen. The following screens will be dis-
played.
ANN-AUDIO ALL CALL
1=NO ALL CALL ZONE
2=INPUT ZONE 1
3=INPUT ZONE 2
All-Call Options Screen #1
These screens allow the programmer to select which Input Zone will be assigned as the All-Call Zone.

ANN-SEC Enable

The ANN-SEC option must be enabled if any modules are connected to the ANN-SEC option card at J13. To enable the Secondary
ANN-BUS, press 2 while viewing ANN-BUS Screen #3 so that the display reads ANN-SEC ENABLE YES. Each press of the 2 key will
cause the display to toggle between ANN-SEC ENABLE YES and ANN-SEC ENABLE NO. The factory default setting is ANN-SEC
ENABLE NO.
74
Pressing 3 for ANN-RLY Options while viewing ANN-BUS Screen #2 will cause the following screen to be
displayed:
ANN-RLY OPTIONS
1=RELAY 1
2=RELAY 2
3=RELAY 3
ANN-RLY Options Screen
Pressing 1 for ANN-AUDIO Options while viewing ANN-BUS Screen #3 will cause the following screen to
be displayed:
ANN-AUDIO OPTIONS
1=ALL CALL ZONE
ANN-AUDIO Options Screen
ANN-AUDIO ALL CALL
1=INPUT ZONE 3
2=INPUT ZONE 4
3=INPUT ZONE 5
All-Call Options Screen #2
IN ZONE 1
IN ZONE 2
IN ZONE 3
1
ANN-AUDIO ALL CALL
1=INPUT ZONE 6
2=INPUT ZONE 7
3=INPUT ZONE 8
All-Call Options Screen #3
(SFP-10UD Only)
SFP-5UD & SFP-10UD Series Manual— P/N 52879:C6 6/12/2018
Master Programming Level
ANN-AUDIO ALL CALL
1=INPUT ZONE 9
2=INPUT ZONE 10
All-Call Options Screen #4
(SFP-10UD Only)