Installation
N-ANN-I/O Connection to FACP
The N-ANN-I/O connects to the FACP via the ANN-BUS as illustrated in Figure 2.25. After the N-ANN-I/O is connected to the panel,
it must be added to the system via FACP programming.
Primary ANN-BUS
N-ANN-I/O Module LED Wiring
There are four 12-pin connectors on the N-ANN-I/O module for connecting LEDs. Each set of 10 LEDs get their power from Pin 11 of
the corresponding connector. Internal resistors are sized so that there is approximately 10 mA of current for each LED. No series resis-
tors are required. LED outputs are mapped to output circuits. Refer to the section titled "ANN-I/O LED Zone Assignments" on page 72
of this manual.
44
TB3
Figure 2.25 ANN-I/O Connection to FACP
ANN-I/O Module
ANN-BUS and power wiring are
supervised and power-limited
SFP-5UD & SFP-10UD Series Manual— P/N 52879:C6 6/12/2018
ANN-BUS Devices