Table of Contents
Advertisement
At trouble
The watch displays an
Misalignment
incorrect time hour unit,
of the time
even though it displays the
The time zone selection is incorrect.
and hand
precise time of minutes
positions
and seconds.
The date is out of the preliminary
The reception results are
position.
successful and the precise
Misalignment
This happens when the date is out of
time is displayed, but the
of the date
the preliminary position as a result of
date is not correctly
influence of various external sources or
displayed.
after the built-in IC is reset.
The stored electric power is running
short.
The crown or button
Operation
Hands and date are moving right after
cannot be operated.
a setting is carried out by the crown or
button operation.
7
76
EN
In case of an abnormal movement
In the case that the watch moves abnormally or that the watch does not move at one-second intervals even
after fully charging the battery, then it can be returned to normal operation using the following operation.
■ Reset the system
1
Pull the crown to the second click.
The seconds hand stops on the spot.
* When the crown is a screw lock type, unlock it.
→ P.13
7
78
EN
Possible causes
Solutions
Check the selected time zone and set it
to the area where the watch is used.
Set the date to the preliminary position
"1" (the 1st).
Sufficiently charge the watch until it
starts moving at one-second intervals.
Wait without doing anything.
After the date stops, the crown and
button can be operated.
Pull out the
0 1 2
crown to the
second click
Reference
At trouble
P.30
You get lost in the middle
Operation
of the operation.
P.67
Blur on the dial glass
Others
persists.
P.36
* For the solution of troubles other than the above, consult the retailer from whom the watch was purchased.
-
2
Press and hold the button for 5 seconds
and then release it.
After releasing the button, approximately 5 seconds
later the seconds hand moves, and stops at the
0-second position.
Then the hour and minute hands will start to move
and stop pointing to 12 o'clock 0 minutes.
* The button cannot be operated until all the hands stop.
3
When all the hands stop pointing to 12 o'clock 0 minutes and 0 seconds, push
the crown back.
The seconds hand starts moving from 12 o'clock 0 minutes and 0 seconds.
* After a system reset, the time zone is set to JJY.
After completion of a system reset, perform the following operations.
• "Set the preliminary position for the date, and the hour and minute hands." → P.67
• "How to select the time zone (How to display the local time around the world)" → P.30
• "How to conduct manual reception (Receive a radio signal manually)" → P.58
* When the crown is a screw lock type, lock it. → P.13
Possible causes
Solutions
Return to the status before the start of
the operation, and try the operation
again.
If the crown is pulled out, push it in.
-----------
If the crown is not pulled out, then pull it
out and push it in again.
This will return to one-second interval
movement for a maximum of 9 minutes.
After this, try the operation again.
A small amount of water has got inside
Contact the retailer from whom the
the watch due to deterioration of the
watch was purchased.
gasket, etc.
Reference
-
-
7
77
EN
Press and hold the
button for 5 seconds
and then release it
7
79
EN
Advertisement
Table of Contents
